Rockwell Automation Logix5000 Control Systems: Connect Kinetix 5500 Drives on EtherNet/IP Network Quick Start User Manual
Page 27
Rockwell Automation Publication IASIMP-QS035A-EN-P - December 2012
27
Prepare the Kinetix 5500 Drive Hardware Chapter 1
2.
Position the exposed portion of the cable braid directly in line with the clamp.
3.
Tighten the clamp screws to a torque value of 2.0 N•m (17.7 lb•in) max.
4.
Repeat
step 1
through
step 3
for each drive in multi-axis configurations.
Motor Cable
Shield Clamp
Motor Power
(MP) Connector
Motor Brake
(BC) Connector
Exposed shield braid
under clamp.
Cable clamp screws
tightened.
Feedback cable routed
within the shield braid.
Kinetix 5500 Servo Drives
(frame 2 or 3) Front View
2198-KITCON-DSL
Motor Feedback
Connector Kit
Retention Screw
(loosen, do not remove)
Clamp features apply to all
frame sizes.
Torque clamp screws to
2.0 N•m (17.5 lb-in), max
2090-CSBM1DF-14AAxx or
2090-CSBM1DF-10AAxx Motor Cables
14 and 10 AWG Cable Installation
TIP
When the drive/motor combination calls for 14 or 10 AWG cable, the feedback cable routes along with the power and brake wiring.