Rockwell Automation Logix5000 Control Systems: Connect Kinetix 5500 Drives on EtherNet/IP Network Quick Start - Manual (Page 35)

Rockwell Automation Publication IASIMP-QS035A-EN-P - December 2012 35
Add a Kinetix 5500 Drive to a Logix Designer Application Chapter 2
13. Type the axis Name.
AXIS_CIP_DRIVE is the default Data Type.
14. Click Create.
The axis (Axis_1 in this example) appears in the Controller Organizer under Motion Groups>Ungrouped
Axes and is assigned as Axis 1 on the Associated Axes tab.
15. Click Apply.
16. Click the Power tab.