Rockwell Automation Logix5000 Control Systems: Connect Kinetix 5500 Drives on EtherNet/IP Network Quick Start - Manual (Page 31)

Rockwell Automation Publication IASIMP-QS035A-EN-P - December 2012 31
Chapter
2
Add a Kinetix 5500 Drive to a Logix Designer Application
In this chapter, you add the Kinetix 5500 servo drive to your Logix Designer application project, download the
project to the Logix5000 controller, and verify communication between drive and motor by applying power and
testing an axis.
Before You Begin
Complete wiring the connector plugs, connecting the Ethernet cables, and configuring the IP address for your
Kinetix 5500 drive (refer to
Chapter 1 ).
What You Need
• Logix Designer application, version 21.00 or later
• The Kinetix 5500 Servo Drives User Manual, publication 2198-UM001