Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 - Manual (Page 32)

3 • I NSTALLING THE F ACTORY T ALK A SSET C ENTRE SERVER
26
•
•
•
• •
 Stop FactoryTalk AssetCentre Website. This is part of the internal working of the
program and is stopped automatically. You may see a command prompt briefly before
the website stops.
 FactoryTalk AssetCentre Common Components. See “FactoryTalk AssetCentre
Common Components installer” on page 31.
 FactoryTalk AssetCentre Server. See “FactoryTalk AssetCentre server installer” on
page 31.
 FactoryTalk AssetCentre Calibration Management Server. See “FactoryTalk
AssetCentre Calibration Management Server installer” on page 34.
 FactoryTalk AssetCentre Process Device Configuration Server. See “FactoryTalk
AssetCentre Process Device Configuration Server installer” on page 35.
 Start FactoryTalk AssetCentre Website. This is part of the internal working of the
program and is started automatically. You may see a command prompt briefly before
the website starts.
 Install AssetCentre Setup Programs. This occurs in step 3 on page 35.
 Launch Rockwell Windows Firewall Configuration Utility. See “Using the
Windows Firewall Configuration Utility” on page 35.
 Start FactoryTalk AssetCentre Server. The installation program starts the service.
The following sections of this chapter provide installation instructions for these
components. Each installation automatically starts after the previous one.
Installing FactoryTalk Services Platform
See “Installing the FactoryTalk AssetCentre server software” on page 23 for the steps to get to
this part of the installation.
FactoryTalk AssetCentre depends on the Rockwell Software FactoryTalk Services
Platform to function. If the platform is not installed on your computer (or if the correct
version is not installed), the setup program will install it. If you have a previous version of
the platform installed, you may need to uninstall it before continuing (the setup program
will inform you if this is the case).
1. Follow the on-screen instructions to install the platform. If FactoryTalk Services
Platform 2.10.00 or later is already installed on your computer, go to step .
By default, all members of the Administrators group on the computer on which you are installing
the FactoryTalk Services Platform are added to the Administrators group in the FactoryTalk
Directory.
FTAC-IN005A-EN-E.book Page 26 Monday, March 4, 2013 4:03 PM