Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 - Manual (Page 47)

4 • I NSTALLING F ACTORY T ALK A SSET C ENTRE CLIENTS
41
•
•
•
• •
The following components are checked for and installed or configured during the client
installation:
 Windows Installer 3.1 v2. If this component is not already installed on your
computer, the setup program will install it. Follow the on-screen installation
instructions. If you are prompted to restart when the installation is complete, close
Microsoft Internet Explorer and any FactoryTalk AssetCentre installation windows
before restarting.
 Microsoft .NET Framework 3.5 and 4.0. The FactoryTalk AssetCentre client
requires that Microsoft .NET Framework versions 3.5 and 4.0 be installed on your
computer. If this component is not already installed on your computer, the setup
program will install it. Follow the installation instructions on-screen to install it.
If a message appears asking to restart the computer, select No and then click Start on
the Install FactoryTalk AssetCentre Client window.
 FactoryTalk AssetCentre Upgrade Check. Checks for an existing CPR 7 version of
FactoryTalk AssetCentre. Version 5.00 works with all CPR 9 versions of FactoryTalk
Services Platform and cannot be installed with an existing CPR 7 version of
FactoryTalk AssetCentre. To upgrade, see Chapter 2 “Upgrading from version 2.00
(CPR 7) to 5.00 (CPR 9 SR 6)” beginning on page 12.
 FactoryTalk Services Platform. See “Installing FactoryTalk Services Platform,”
next.
 RSLinx Classic Lite. See step 4 on page 43.
 RSLinx Enterprise. See step 11 on page 44.
 Patch FTSP. FactoryTalk Services Platform patches are installed depending on
whether FactoryTalk Services Platform is installed on the computer:
 If the computer already has FactoryTalk Services Platform, patches are installed
during the FactoryTalk Services Platform installation (beginning on page 42). This
installs the most recent patches at the time the FactoryTalk AssetCentre
installation disc was created. More recent patches may be available. If you have
not already checked your FactoryTalk Services Platform patches, skip the patch
during the installation and see “Before you begin, check and install FactoryTalk
Services Platform and FactoryTalk View patches” on page 14 for more
information about validating and installing patches.
 If the computer does not have an existing version of FactoryTalk Services
Platform, no patches are necessary. FactoryTalk Services Platform CPR 9 SR 6
will be installed as part of the FactoryTalk AssetCentre installation.
FTAC-IN005A-EN-E.book Page 41 Monday, March 4, 2013 4:03 PM