Running the procalv5 data source edit wizard – Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 User Manual

Page 42

Advertising
background image

3

I

NSTALLING

THE

F

ACTORY

T

ALK

A

SSET

C

ENTRE

SERVER

36

• •

page 82 to configure your firewall to allow communication through the appropriate
ports and with specific processes.

If your Windows Firewall/Internet Connection Sharing (ICS) service is running, the
FactoryTalk AssetCentre Windows Firewall Configuration window indicates this with
a green check mark. Click Start. The Rockwell Software Windows Firewall
Configuration Utility window opens. The list of exceptions (things to allow through
the firewall) generally includes default SQL Server and e-mail ports.

If no exceptions need to be made, none are listed and the Accept button is
unavailable. In that case, click Exit to close this utility.

If exceptions are listed, click Accept. On the Confirm Windows Firewall Changes
window make the appropriate selection depending on whether your Windows
Firewall will be on or off, and then click OK.

Installing the ProCalV5 server software after the FactoryTalk
AssetCentre server

If you have purchased the Calibration Management capability for FactoryTalk
AssetCentre, you would normally install the ProCalV5 server software before you install
the FactoryTalk AssetCentre server (as described on page 23). However, if you did not
install the ProCalV5 server before the FactoryTalk AssetCentre server, you can install it
now.

1. Install the ProCalV5 server software as described on page 23.

2. Run the ProCalV5 Data Source Edit Wizard, described next.

Running the ProCalV5 Data Source Edit Wizard

If you installed the ProCalV5 server AFTER you installed the FactoryTalk AssetCentre
server, you must run the ProCalV5 Data Source Edit Wizard to connect the ProCalV5
server to FactoryTalk AssetCentre.

If you installed the ProCalV5 server before you installed the FactoryTalk AssetCentre server, do
not install the ProCalV5 server again.

This step is not necessary if you installed the ProCalV5 server before you installed the
FactoryTalk AssetCentre server.

FTAC-IN005A-EN-E.book Page 36 Monday, March 4, 2013 4:03 PM

Advertising