Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 - Manual (Page 53)

4 • I NSTALLING F ACTORY T ALK A SSET C ENTRE CLIENTS
47
•
•
•
• •
 PG-2000
3. Follow the on-screen instructions to complete the FactoryTalk AssetCentre client
installation.
When finished, there may be a short delay before you see the FactoryTalk AssetCentre
Calibration Management client installer start.
FactoryTalk AssetCentre Calibration Management client
software installer
See “Installing the FactoryTalk AssetCentre client software” on page 39 for the steps to get to this
part of the installation.
After the FactoryTalk AssetCentre client is installed, the FactoryTalk AssetCentre
Calibration Management client installation begins.
1. On the Install FactoryTalk AssetCentre Calibration Management Client window, click
Next.
2. Follow the on-screen instructions to install the FactoryTalk AssetCentre Calibration
Management client.
When finished, there may be a short delay before you see the FactoryTalk AssetCentre
Process Device Configuration client installer start.
FactoryTalk AssetCentre Process Device Configuration client
software installer
See “Installing the FactoryTalk AssetCentre client software” on page 39 for the steps to get to this
part of the installation.
To successfully integrate the S5 or S7 editors, you must install the editors before the
FactoryTalk Asset Centre installation. Otherwise, you may receive an information
message indicating that the required file for the installed editor could not be found and
the editor could not be integrated.
The FactoryTalk AssetCentre Calibration Management client must be installed in the same folder
as the FactoryTalk AssetCentre client.
The FactoryTalk AssetCentre Process Device Configuration client must be installed in the same
folder as the FactoryTalk AssetCentre client.
FTAC-IN005A-EN-E.book Page 47 Monday, March 4, 2013 4:03 PM