Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 - Manual (Page 40)

3 • I NSTALLING THE F ACTORY T ALK A SSET C ENTRE SERVER
34
•
•
•
• •
6. When the settings are as desired, click OK.
7. If you see messages indicating that the firewall has blocked a program, select
Unblock on each message.
8. On the final page of the FactoryTalk AssetCentre Server InstallShield Wizard, click
Finish.
FactoryTalk AssetCentre Calibration Management Server
installer
See “Installing the FactoryTalk AssetCentre server software” on page 23 for the steps to get to
this part of the installation.
To install the Calibration Management server:
1. Follow the on-screen instructions.
2. After you install the FactoryTalk AssetCentre Calibration Management server, the
ProCalV5 Connection Installer window opens. This step installs the database
connection for ProCalV5. Provide this information from the ProCalV5 server
installation:
 The name of the SQL Server for the ProCalV5 database.
 The ProCalV5 SQL Server login name (default is pcV5us01) and password.
 The name of the ProCalV5 SQL database (default is PROCAL55RS).
3. Click OK.
4. In the Test Data Source window, click Test Data Source.
SMTP Server IP Port Sets the IP port used to communicate with your SMTP server. By
default, this port is 25. Some facilities use a different port. If you do not
know your SMTP port number, consult your network administrator.
If you use a port other than 25 and are using a firewall, you’ll have to
also open that port in your firewall.
The FactoryTalk AssetCentre Calibration Management server must be installed in the same
folder as the FactoryTalk AssetCentre server.
If you have not installed the ProCalV5 server software, click Skip and go to step 6. You can
install the ProCalV5 software after installing the FactoryTalk AssetCentre server software,
and then create the ProCalV5 connection (as described on page 36).
This setting: Does this:
FTAC-IN005A-EN-E.book Page 34 Monday, March 4, 2013 4:03 PM