Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 - Manual (Page 54)

4 • I NSTALLING F ACTORY T ALK A SSET C ENTRE CLIENTS
48
•
•
•
• •
After the FactoryTalk AssetCentre Calibration Management client is installed, the
FactoryTalk AssetCentre Process Device Configuration client installation begins. This
installs the client component of the Process Device Configuration capabiltiy and the Field
Edition software.
1. On the Install FactoryTalk AssetCentre Process Device Configuration Client window,
click Next.
2. Follow the on-screen instructions to install the FactoryTalk AssetCentre Process
Device Configuration client.
3. If asked to restart your computer, click Yes.
A FTER RESTARTING
The installation software will initiate several component installations again in sequence
beginning with the FactoryTalk Services Platform. You can cancel the installation for all
components that you have already installed. The list below provides a step-by-step
sequence to cancel all installs that have been completed to this point. What you see may
vary depending on your particular system.
1. Click Start on the Install FactoryTalk AssetCentre Client window.
2. Click Finish on the FactoryTalk Services Platform Patch Installation window if it
opens.
3. Depending on your FactoryTalk Directory setting, you may see the stop sign window
again about how to set the FactoryTalk Directory. See step 20 on page 45 to make the
appropriate choice.
4. Click Continue on the Check FactoryTalk Services Platform Configuration window.
Using the Windows Firewall Configuration Utility
See “Installing the FactoryTalk AssetCentre client software” on page 39 for the steps to get to this
part of the installation.
The Windows Firewall Configuration Utility runs whether you are using the firewall or
not.
 If your Windows Firewall/Internet Connection Sharing (ICS) service is stopped or is
disabled, the FactoryTalk AssetCentre Windows Firewall Configuration window will
indicate this with a red x. Click Continue. The FactoryTalk AssetCentre server
installation is complete.
If you are using a firewall other than Windows Firewall, use the information in
“Network requirements” on page 9 and “Additional ports you may have to open” on
FTAC-IN005A-EN-E.book Page 48 Monday, March 4, 2013 4:03 PM