Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1190)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1174 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Mapping range and unit of the value are defined in the configuration of the
analog output.
If the value that is to be written is less than 0% mapping, then the smallest
possible value (low level (0%)) will be output; in the case of values greater
than 100% mapping, the largest possible value (high level (100%)) will
be output.
5.6.11.5 ANALOG IN
5.6.11.5.1 ANALOG IN - Overview
Dialog window: Method ▶ ANALOG IN ▶ Properties... ▶ ANALOG IN - 'Command
name'
Devices
This command can be executed with the IO Controller.
Appearance
The command has the following appearance:
Mode of operation
The statuses of all analog inputs will be entered and saved in command
variables at the time of the command.
Parameters
The parameters for the command ANALOG IN are configured on the fol-
lowing 2 tabs:
￭ General
Parameters for device.
￭ Stop criteria
Parameters for the definition of the stop criteria.
Command variables
The following command variables are generated in the method run by the
command ANALOG IN and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started