Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 444)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
428 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Parameters
The END command does not have any parameters. It is created automati-
cally at the end of a track when a new track is inserted.
Command variables
No command variables are generated in the method run by the END com-
mand.
5.6.3 Titration commands
5.6.3.1 Titration commands - Overview
Menu item: Method ▶ Insert ▶ New command...
Commands for titrations.
Modes
The following titration commands can be selected:
￭ DET
Command for Dynamic Equivalence Point Titrations.
￭ MET
Command for Monotonic Equivalence Point Titrations.
￭ (see Chapter 5.6.3.4.1, page 640)
Command for Set Endpoint Titrations.
￭ KFT
Command for volumetric Karl Fischer Titrations.
￭ KFC
Command for coulometric Karl Fischer Titrations with voltametric meas-
urement.
￭ BRC
Command for coulometric titration for determining the bromine con-
sumption.
￭ STAT
Command for STAT Titrations.
5.6.3.2 DET
5.6.3.2.1 DET - Overview
Menu item: Method ▶ Paste ▶ New command...
Command for Dynamic Equivalence Point Titrations.
Principle
With this command titrations with dynamic incremental reagent addition
are carried out. The volume increments vary as a function of the slope of the