4 stat ph - control parameters, Control parameters – Metrohm tiamo 2.1 (ProcessLab) User Manual
Page 830
5.6 Commands
■■■■■■■■■■■■■■■■■■■■■■
814
■■■■■■■■
tiamo 2.1 (ProcessLab)
Selection
maximum
Default value
maximum
Titrino
Range
0.01 ... 150.00 mL/min
Selection
maximum
Default value
maximum
Pause 2
Pause 2
Waiting time, e.g. for the electrode to settle down after the start or a reac-
tion time after the addition of the start volume. The pause follows at the
end of all the start conditions.
Range
0 ... 999999 s
Default value
0 s
5.6.3.8.6.4
STAT pH - Control parameters
Tab: Method
▶ STAT pH ▶ Properties... ▶ Control parameters
Command name
Name of the command.
Input
25 characters
Control point
Control point at pH
Definition of the pH value to be controlled.
Titrando, 855
Range
-20,000 ... 20,000
Selection
off
Default value
off
Titrino
Range
-20.00 ... 20.00
Selection
off
Default value
off
Titration rate
Titration rate
Three predefined rates, for which the parameters for Control are not dis-
played, can selected for the titration rate. The User setting must be selected
in order to be able to edit these parameters.