Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 940)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
924 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
5.6.4.7 MEAS T/Flow
5.6.4.7.1 MEAS T/Flow - Overview
Dialog window: Method ▶ MEAS T/Flow ▶ Properties... ▶ MEAS T/Flow - 'Command
name'
Command for Temperature and gas flow measurements.
Devices
This command can be executed with the following devices:
Sample Processor: 774, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS T/Flow are configured on the
following 4 tabs:
￭ General/Hardware
Parameters for device.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluation
Defining further methods for evaluating measurement curves.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS T/Flow and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s