NISSAN 2011 Quest - Owner's Manual - Manual (Page 135)

Black plate (129,1)
Model "E52-D" EDITED: 2010/ 10/ 25
for about 45 seconds after the ignition switch is
pushed to the OFF position.
If the moonroof cannot be closed automatically
when the auto reverse function activates due to
a malfunction, push and hold the moonroof
switch to the close position
*
B .
Depending on the environment or driving
conditions, the auto reverse function may
be activated if an impact or load similar to
something being caught in the moonroof
occurs.
IF THE FRONT OR REAR MOONROOF
DOES NOT OPERATE
If the front or rear moonroof does not operate
properly, perform the following procedure to
initialize the moonroof operation system. Initiali-
zation can be performed for both the front
moonroof and rear moonroof.
1. If the moonroof is open, close it fully by
pushing and holding the moonroof switch to
the close position
*
B until the moonroof
tilts up.
2. Release the moonroof switch, then push and
hold the
*
B side again for more than 10
seconds.
3. Release the moonroof switch, then continue
to push on the
*
B side again. The moonroof
will operate in the close direction. (The
moonroof operates inch by inch.)
4. After the moonroof stops moving, release
the moonroof switch and within 4 seconds,
push side
*
B again. The moonroof will
automatically open once.
5. Within 0.5 seconds after the moonroof
stops moving, release the moonroof switch.
6. Check that the moonroof now operates
normally.
If the moonroof does not operate properly after
performing the procedure above, have your
vehicle checked by a NISSAN dealer.
SIC4745
MAP LIGHTS
Push the button as illustrated to turn the light on
or off.
INTERIOR LIGHTS
Instruments and controls 2-53