Warning – NISSAN 2011 Quest - Owner's Manual User Manual
Page 43
Black plate (37,1)
Model "E52-D" EDITED: 2010/ 10/ 25
Stowing 3rd row center seat belt:
When folding down the 3rd row seat, the 3rd
row center seat belt can be retracted into a
stowed position as follows:
1. Hold the connector tongue
*
1
so that the
seat belt does not retract suddenly when the
tongue is released from the connector
buckle. Release the connector tongue by
inserting a suitable tool such as key
*
A
into
the connector buckle.
2. Insert the seat belt tongue into the retractor
base first
*
2
.
3. Then secure the connector tongue into the
retractor base
*
3
.
WARNING
Do not unfasten the 3rd row center seat
belt connector except when folding
down the rear seat.
SSS1165
Attaching 3rd row center seat belt:
Always be sure the 3rd row center seat belt
connector tongue and connector buckle are
attached. Disconnect only when folding down
the 3rd row seat.
To connect the buckle:
1. Pull out the connector tongue from the
retractor base
*
1
.
2. Pull out the seat belt tongue from the
retractor base
*
2
.
3. Pull the seat belt and secure the connector
buckle until it clicks
*
3
.
The center seat belt connector tongue and
buckle are indicated by the
! and ~ mark.
The center seat belt connector tongue can be
attached only into the 3rd row center seat belt
connector buckle.
To fasten the seat belt, see “Fastening the seat
belts” earlier in this section.
WARNING
. When attaching the 3rd row center
seat belt connector, be certain that
the seatbacks are completely se-
cured in the latched position and
the 3rd row center seat belt con-
Safety — Seats, seat belts and supplemental restraint system
1-23