NISSAN 2011 Quest - Owner's Manual - Manual (Page 62)

Black plate (56,1)
Model "E52-D" EDITED: 2010/ 10/ 25
SSS1088
2nd row seat
INSTALLING TOP TETHER STRAP (2nd
row seats)
First, secure the child restraint with the LATCH
lower anchors or the seat belt, as applicable.
1. If necessary, raise or remove the head
restraint or headrest to position the top
tether strap over the top of the seatback. If
the head restraint or headrest is removed,
store it in a secure place. Be sure to reinstall
the head restraint or headrest when the child
restraint is removed. See “HEAD RE-
STRAINTS” earlier in this section for head
restraint or headrest adjustment, removal
and installation information.
2. Secure the tether strap to the tether anchor
point on the back of each seatback behind
the child restraint.
3. Tighten the tether strap according to the
manufacturer’s instructions to remove any
slack. Make sure the head restraint or
headrest does not contact the top tether
strap.
If you have any questions when installing a
top tether strap on the rear seat, consult
your NISSAN dealer for details.
SSS1168
3rd row seat
INSTALLING TOP TETHER STRAP (3rd
row seat)
WARNING
In the 3rd row seat, a child restraint with
a top tether strap can only be used in
the center and right side position. Do
not place in the left side seating posi-
tion and attempt to angle the tether
strap to the center or right side posi-
tion.
The center and right side position of the 3rd row
seat is the seating position that can use a top
1-42 Safety — Seats, seat belts and supplemental restraint system