NISSAN 2011 Quest - Owner's Manual - Manual (Page 245)

Black plate (239,1)
Model "E52-D" EDITED: 2010/ 10/ 25
13. AUX IN jack
14. TUNE/SCROLL CONTROL dial
15. ENTER/SETTING button
FM-AM RADIO WITH COMPACT DISC
(CD) PLAYER
Audio main operation
Head unit:
The auto loudness circuit enhances the low and
high frequency ranges automatically in both
radio reception and CD playback.
ON·OFF/Volume control:
Push the ignition switch to the ACC or ON
position, and then push the ON·OFF button
while the system is off to turn on the last audio
source (i.e. FM or CD), which was playing
immediately before the system was turned off.
While the system is on, pushing the ON·OFF
button turns the system off.
Turn the VOL control knob to adjust the volume.
SETTING button:
Push the button to change the selecting mode
as follows.
Push the TUNE/SCROLL control dial to adjust
Bass and Treble to the desired level. Use the
TUNE/SCROLL control dial also to adjust Fade
or Balance modes. Fade adjusts the sound level
between the front and rear speakers and
Balance adjusts the sound between the right
and left speakers.
To change the Speed Sensitive Volume (Spd
Sen Vol) mode from off (0) to 5, and push the
TUNE/SCROLL control dial until the desired
mode is displayed.
Turn the TUNE/SCROLL control dial to adjust
the brightness and contrast of the screen to the
preferred level.
Clock adjustment:
Push the ENTER SETTING button until “Setting
Clock” and “On-screen Clock” appear on the
display. Then turn the TUNE/SCROLL control
dial to turn the clock on or off.
1. Push the ENTER SETTING button until
“Setting Clock” and “Clock Adjust” appear
on the display.
2. Turn the TUNE/SCROLL control dial to
adjust the hour.
3. Push the ENTER SETTING button.
4. Turn the TUNE/SCROLL control dial to
adjust the minute.
5. Push the ENTER SETTING button.
The display will return to the regular clock
display after 5 seconds.
Switching the display:
Pushing the AUX button will switch the displays
as follows:
iPod ® /USB ? AUX ? iPod ® /USB
FM-AM radio operation
radio (FM/AM) band select:
Pushing the radio band select button will
change the band as follows:
AM ? FM1 ? FM2 ? AM
When the radio band select button is pushed
while the ignition switch is in the ACC or ON
position, the radio will come on at the channel
last played.
The last channel played will also come on when
the ON·OFF button is pushed to ON.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-61