NISSAN 2011 Quest - Owner's Manual - Manual (Page 217)

Black plate (211,1)
Model "E52-D" EDITED: 2010/ 10/ 25
Cooling:
This mode is used to cool and dehumidify the air.
1. Push the outside air circulation “ ”
button to switch to the outside air circulation
mode. (The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to set
the desired fan speed.
4. Push the A/C button on. (The A/C indicator
light will illuminate.)
5. Push the temperature control buttons to set
the desired temperature between the middle
and the cool position.
. For quick cooling when the outside tem-
perature is high, push the air recirculation
button to switch to the air recirculation
mode. (The indicator light turns on.) Be sure
to turn off the air recirculation mode for
normal cooling.
. A visible mist may be seen coming from the
ventilators in hot, humid conditions as the air
is cooled rapidly. This does not indicate a
malfunction.
Dehumidified heating:
This mode is used to heat and dehumidify the
air.
1. Push the outside air circulation “ ”
button to switch to the outside air circulation
mode. (The indicator light turns on.)
2. Push the air flow control button to change to
the position.
3. Push the fan speed control buttons to the
desired fan speed.
4. Push the A/C button on. (The A/C indicator
light will illuminate.)
5. Push the temperature control buttons to set
the desired temperature between the middle
and the hot position.
Dehumidified or defrosting/defogging:
This mode is used to defog the windows and
dehumidify the air.
1. Push the front defroster button on.
(The indicator light turns on.)
2. Push the fan speed control buttons to set
the desired fan speed.
3. Push the temperature control buttons to set
the desired temperature.
When the mode is selected, the air
conditioner will automatically turn on. This will
dehumidify the air and help to defog the
windows. The A/C indicator light will illuminate
when the air conditioner automatically turns on.
The air conditioner and A/C indicator light will
remain on in all flow control modes until the A/C
button is pushed.
To remove frost from the outside surface of the
windshield quickly, set the temperature to the
maximum hot position and the fan speed to
maximum position.
Rear air conditioning system
Operating from front control buttons:
To control the rear air conditioning system
independently with the front air conditioner
control panel, push the “REAR” button. When
the rear air conditioning system control is on, the
indicator light on the “REAR” button will
illuminate and “REAR” will appear on the display.
In this state, the rear air conditioning system can
be adjusted with the front air conditioner control
panel. However, if no operation is conducted for
approximately 10 seconds after the “REAR”
button is pushed, the front air conditioner
control panel will automatically switch to the
front air conditioning mode.
To cancel the rear air conditioning mode and
switch back to the front air conditioning mode,
push “REAR” button one more time.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-33