NISSAN 2011 Quest - Owner's Manual - Manual (Page 51)

Black plate (45,1)
Model "E52-D" EDITED: 2010/ 10/ 25
SSS0644
LATCH rigid attachment
The child restraint top tether strap must be used
when installing the child restraint with the
LATCH lower anchor attachments or seat belts.
See “TOP TETHER STRAP CHILD RE-
STRAINT” later in this section for installation
instructions.
When installing a child restraint, carefully read
and follow the instructions in this manual and
those supplied with the child restraint.
SSS1088
2nd row seat
SSS1168
3rd row seat
TOP TETHER STRAP CHILD RE-
STRAINT
If the manufacturer of your child restraint
requires the use of a top tether strap, it must
be secured to an anchor point.
WARNING
. In the 3rd row seat, a child restraint
with a top tether strap can only be
used in the center position. Do not
place in an outboard seating posi-
tion and attempt to angle the tether
strap to the center position.
. Child restraint anchor points are
designed to withstand only those
loads imposed by correctly fitted
child restraints. Under no circum-
stances are they to be used for adult
seat belts or harnesses.
. Do not allow cargo to contact the
top tether strap when it is attached
to the top tether anchor. Properly
secure the cargo so it does not
contact the top tether strap. Cargo
that is not properly secured or cargo
that contacts the top tether strap
may damage the top tether strap
during a collision. Your child could
Safety — Seats, seat belts and supplemental restraint system 1-31