Caution – NISSAN 2011 Quest - Owner's Manual User Manual

Page 174

Advertising
background image

Black plate (168,1)

Model "E52-D" EDITED: 2010/ 10/ 25

cle.

. Close the sliding door before open-

ing the fuel-filler door.

. Do not fill a portable fuel container

in the vehicle or trailer. Static elec-
tricity can cause an explosion of
flammable liquid, vapor or gas in
any vehicle or trailer. To reduce the
risk of serious injury or death when
filling portable fuel containers:

— Always place the container on

the ground when filling.

— Do not use electronic devices

when filling.

— Keep the pump nozzle in contact

with the container while you are
filling it.

— Use only approved portable fuel

containers for flammable liquid.

CAUTION

. If fuel is spilled on the vehicle body,

flush it away with water to avoid
paint damage.

. Insert the cap straight into the fuel-

filler tube, then tighten until the
fuel-filler cap clicks. Failure to tight-

en the fuel-filler cap properly may
cause the

malfunction indicator

light (MIL) to illuminate. If the
light illuminates because the fuel-
filler cap is loose or missing, tighten
or install the cap and continue to
drive the vehicle. The

light

should turn off after a few driving
trips. If the

light does not turn

off after a few driving trips, have the
vehicle inspected by a NISSAN deal-
er.

For additional information, see
“Malfunction Indicator Light (MIL)”
in the “2. Instruments and controls”
section.

. The LOOSE FUEL CAP warning will

appear if the fuel-filler cap is not
properly tightened. Failure to tight-
en the fuel-filler cap properly after
the LOOSE FUEL CAP warning ap-
pears may cause the

Malfunc-

t i o n I n d i c a t o r L i g h t ( M I L ) t o
illuminate.

SPA2826

To remove the fuel-filler cap:

1. Turn the fuel-filler cap counterclockwise

*

1

to remove.

2. Hang the tether of the cap on the hook

*

3

while refueling.

To install the fuel-filler cap:

1. Insert the fuel-filler cap straight into the fuel-

filler tube.

2. Turn the fuel-filler cap clockwise

*

2

until a

single click is heard.

3-30

Pre-driving checks and adjustments

Advertising