NISSAN 2011 Quest - Owner's Manual - Manual (Page 242)

Black plate (236,1)
Model "E52-D" EDITED: 2010/ 10/ 25
stop at the station.
SCAN searching:
Push the SCAN tuning button to tune from low
to high frequencies and stop at each broad-
casting station for 5 seconds. Pushing the
button again during this 5-second period will
stop SCAN tuning and the radio will remain
tuned to that station.
If the SCAN tuning button is not pushed within 5
seconds, SCAN tuning moves to the next
station.
Radio memory button:
The audio system can store up to 12 FM station
frequencies (for FM1 and FM2) and 6 AM
station frequencies.
To store the station frequency:
1. Tune to the desired broadcasting station
frequency by using the TUNE button or
SEEK button.
2. Push and hold a memory button (1 - 6) until
a beep sounds.
3. The channel indicator will display indicating
that the memory is stored properly.
4. Perform steps 1 - 3 for all other memory
buttons.
If the battery cable is disconnected, or if the
audio fuse blows, the radio memory will be
erased. In such a case, reset the desired
stations.
CD changer operation
The audio system operates when the ignition
switch is in the “ACC” or “ON” position.
CAUTION
. Do not force the compact disc into
the slot. This could damage the
player.
. Do not use 8 cm (3.1 in) discs.
LOAD button:
To load a CD in the CD changer:
1. Push the button for less than 1.5
seconds.
2. Select the loading slot by pushing the CD
select buttons to . If no slot is
selected, the CD changer will automatically
select a slot which is available.
3. Insert a CD into the slot with the label side
facing up. The CD will be guided automa-
tically into the slot and will start playing.
To load 6 CDs in the CD changer in succession,
push the
button for more than 1.5 seconds.
If another audio source is already playing, it will
automatically turn off and the CD will start
playing.
After loading the CD, the number of tracks and
the play time will appear on the display.
CD button:
When the CD button is pushed while the audio
system is off and CDs are loaded, the audio
system will turn on and a CD will start playing.
If another audio source is playing when the CD
button is pushed with CDs loaded, the audio
source will automatically turn off and a CD will
start playing.
button:
To display the CD text on the screen (text
programmed CD only), push the DISP button
while a CD is being played. The following CD
text will be displayed on the screen.
(CD)
4-58 Monitor, heater, air conditioner, audio, phone and voice recognition systems