NISSAN 2011 Quest - Owner's Manual - Manual (Page 222)

Black plate (216,1)
Model "E52-D" EDITED: 2010/ 10/ 25
detects odors and gas to automatically
switch between the air recirculation
mode and the outside air circulation
mode. (See “Advanced climate control
system” later in this section for details.)
Models without Advanced Climate Control
System (ACCS):
Push and hold the air recirculation
“
” button or outside air circulation
“ ” button (the one with the indicator
light on) for more than 2 seconds to set
the automatic control between the air
recirculation and outside air circulation
modes. (The “
” or “ ” indicator
light will blink twice.)
The following conditions need to be met for
the automatic air intake control mode to
function properly.
. The air flow control is not in the front
defogger mode (the indicator light on
the front defroster “
FRONT” button
is turned off).
. The outside temperature is approxi-
mately 32 8F (08C) or above.
NOTE:
. Do not set the temperature lower than
the outside air temperature. Doing so
may prevent the temperature from
being controlled properly.
. To dehumidify the air, push the “A/C”
button before turning on the heater.
Dehumidified defrosting/defogging:
1. Push the front defroster “ FRONT”
button. (The indicator light will illuminate.)
2. Push the temperature control buttons
(“ ” and “ ”) to set the desired
temperature.
. To remove frost from the outside surface
of the windshield quickly, set the tem-
perature control and fan speed control
to their maximum position.
. After the windshield is cleared, push the
“AUTO” button to set to the automatic
mode.
. When the front defroster “ FRONT”
button is pushed, the air conditioner will
automatically turn on sensing the out-
side air temperature to defog the wind-
shield. Do not select the air recirculation
mode for the best defogging perfor-
mance.
NOTE:
Do not set the temperature too low when
the front defogger mode is on (the indi-
cator on the front defroster “
FRONT”
button is illuminated). Doing so may fog
up the windshield.
Manual operation
The manual mode can be used to control the
heater and air conditioner to your desired
settings.
Fan speed control:
Push the fan speed control button “ ” to
increase the fan speed.
Push the fan speed control button “ ” to
decrease the fan speed.
Push the “AUTO” button to change the fan
speed to the automatic mode.
Air flow control:
Push the “MODE” button to change the air flow
mode.
: Air flows from the center and side
ventilators.
: Air flows from the center and side
ventilators, and foot outlets.
: Air flows mainly from the foot outlets.
4-38 Monitor, heater, air conditioner, audio, phone and voice recognition systems