NISSAN 2011 Quest - Owner's Manual - Manual (Page 154)

Black plate (148,1)
Model "E52-D" EDITED: 2010/ 10/ 25
SPA2547
Power door main switch
SWITCHING SLIDING DOOR OPERA-
TION
Using the power door main switch located on
the instrument panel, you can switch the sliding
door between power and manual operation. To
turn on the power operating mode, push the
switch to the ON position. To turn off the power
operation, push the switch to the OFF position,
and then the sliding door can be manually
operated.
When the power door main switch is pushed to
the “OFF” position, the power operation is not
available by the sliding door switch on the pillar,
sliding door one-touch switch and power assist.
The power sliding door system can be operated
when all of following conditions are satisfied.
. The vehicle is stopped.
. Battery voltage is normal.
. The sliding door is unlocked.
. The fuel-filler door is closed (for driver’s side
only).
When the ignition switch is in the “ON” position,
the system can be operated in the above and
one of the following conditions.
. Selector lever is set in the “P” (Park)
position.
. Brake pedal is depressed.
. Parking brake is applied.
If the conditions are interrupted when the power
sliding door is being operated, the operation
could be stopped. In this case, meet the
conditions above and the power sliding door
operation will return to normal.
You can also switch the power lift gate between
power and manual operation using the power
door main switch. (See “LIFT GATE” later in this
section.)
SPA2846
Instrument panel *
A Driver’s side sliding door switch
*
B Passenger’s side sliding door switch
3-10 Pre-driving checks and adjustments