Kontron CG2200 Carrier Grade Server - Manual (Page 46)

39
Kontron CG2200 Carrier Grade Server Installation and Maintenance Guide
Interconnect #: Name:
KAI Cable
P/N
End #1 Connection
End #2 Connection
End #3 Connection
End #4 Connection
places
16. Fan
(Fans 3-4)
K00546-001
End #1:Fan Control Board
End #2: Fan Pair (3-4) End #3: NA
End #4: NA
17. Fan
(Fans 5-6)
K00546-001
End #1:Fan Control Board
End #2: Fan Pair (5-6) End #3: NA
End #4: NA
18. Mini-SAS 1 (HDD 0-3 /
SGPIO1)
K00547-001
End #1:SAS HDD Backplane Board
End #2: Baseboard SAS 0-3 Conn End #3: Baseboard SGPIO1
End #4: NA
19. Mini SAS 2 (HDD 4-5 /
SGPIO2)
K00548-001
End #1:SAS HDD Backplane Board
End #2: Baseboard SAS 4-5 Conn End #3: Baseboard SGPIO2
End #4: NA
20. HSBP I2C / HDD LED K00549-001
End #1:SAS HDD Backplane Board
End #2: Baseboard HSBP I
2
C
End #3: C-2-C (HDD-LED)
End #4:
4.2 Installing or Replacing Hard Disk Drives
Up to six hot-swappable SAS hard disk drives can be installed in your CG2200 server. The drives go into
carriers that connect to the SAS backplane board once the carriers with drives attached are inserted back
into the drive bay slots. The CG2200 server ships with six drive carriers.
CAUTION: If you install fewer than six hard disk drives, the unused drive slots must contain the empty
carriers with filler panels that ship with the server to maintain proper cooling.
The CG2200 server does not support all SAS HDD or SATA SDD disk drives. To see a list of validated
manufacturers and drive models, refer to the THOL. The latest version of the THOL is located on the
Kontron support website at
http://us.kontron.com/support/ . (Search for CG2200, click on Product
Downloads, then Compatibility Matrix).
NOTE: SATA rotating HDDs are not recommended for use in this system because they are sensitive to
rotational vibration from system fan blades and other HDDs.
You must remove the front bezel to add or replace a hard drive in one of the drive slots. It is not
necessary to remove the chassis cover or to power down the system. The hard drives are hot-swappable.
4.2.1 Removing an HDD Carrier from the Chassis
1. Remove the front bezel. For instructions, see “Removing the Front Bezel”.
2. Select the drive slot where you want to install/replace the drive.
Drive slot 0 must be used first, then drive slot 1 and so on.
(Drive slot numbers are printed on the front panel below the drive slots.)
3. Remove the drive carrier by pressing the green button to open the lever that engages the drive to the
backplane. (Figure 25, “A”).
4. Pull the drive carrier out of the chassis.