Kontron CG2200 Carrier Grade Server - Manual (Page 52)

45
Kontron CG2200 Carrier Grade Server Installation and Maintenance Guide
14. Ensure that the mini-SAS cables are routed under the support cross bar to provide sufficient airflow
clearance for the PCI assembly when it is re-installed. (“K”)
4.4 Installing the SuperCap Module
The Supercap module is a flash-based battery backup module for SAS drives. It comes with the Intel
RS2VB080 RAID controller kit and is not compatible with other RAID products. The mounting bracket
and cable for this module are included in the CG2200 RAID cable kit.
To install the SuperCap module:
1. Insert the SuperCap module into the black plastic tray. (Figure 31, “A”)
2. Fasten the SuperCap and tray assembly to the sheet metal bracket by inserting the tabs into the cut-
outs on bracket. (“B”)
3. Holding the locking lever on the plastic tray out, slide the board towards the back of the bracket until
the module/tray assembly locks into place.
Figure 31. Setting Up the SuperCap Assembly
4. Connect the signal/power pigtail cable to the front of the hardware RAID controller board (“G”) and the
rear of the SuperCap assembly. (Figure 30, “H”)
5. Place the SuperCap assembly on the support cross bar, lining it up with the center hole on the middle
shelf. (“J”)
6. Use the blue retention screw to fasten the SuperCap assembly to the cross bar. (Figure 30, “I”).