Kontron CG2200 Carrier Grade Server - Manual (Page 73)

66
Kontron CG2200 Carrier Grade Server Installation and Maintenance Guide
- Front panel USB cable
- LED/Switch board power and signal cable
- TAM signal cable
Figure 48 shows the location of all the connectors on the FP board.
Figure 48. Front Panel Board Connectors
Item Description Item Description
A TAM signal cable connector E SSI front panel power cable
connector
B USB/RJ45 serial stacked header F LED/switch board power/signal cable
connector
C SD 0 flash module G Multifunction power/signal cable
connector
D SD 1flash module H Front panel board USB cable
connector
CAUTION: Before replacing any of the boards on the CG2200 server, you must first take the server out of
service, turn off all peripheral devices connected to the server, turn off the server by pressing the power
button, and unplug the power cord(s) from the system and wall outlet.
When handling the FP board, observe the normal safety and ESD precautions. See Appendix A: Safety
Information for more information.
5.4.1 Removing the Old Front Panel Board
1. Power down the server and remove all peripheral devices and the power cord(s)
2. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
3. Remove the front bezel. For instructions, see “Removing the Front Bezel”.
4. Remove any SD flash cards in the SD module slots to save for use with the new FP board.