Canon IMAGERUNNER 2010F - Manual (Page 257)

Polling Receiving 9-6
Using P
olling
9
NOTE
• In one operation, you can poll several fax machines. You can dial up to 210
telephone numbers and poll those fax machines in order to receive documents that
they are holding.
• You must perform the next operation within five seconds of specifying the
destination. If you wait longer than the timeout interval, the machine starts dialing
automatically, and you cannot specify the ITU-T subaddress and password. The
timeout interval can be turned ‘OFF’. (See “Time Out Mode,” on p. 4-7.)
• If the other party has set the ITU-T subaddress and password, you need to enter
the same ITU-T subaddress/password in order for your machine to receive their
documents. (See “Setting the RX Password,” on p. 10-12.)
6
Press [Start].
The machine starts dialing the other party to poll and receive the document.
NOTE
To cancel polling receiving, press (Stop). If the message <CANCEL DURING
TX/RX?> is displayed, press (YES).
Setting Up the ITU-T Subaddress and Password for Polling
Receiving
To receive a document held under an ITU-T subaddress and password, you have to
specify them after dialing the other party’s fax number.
1
After entering the fax number of the party you want to poll,
press [Advanced Communication].
The ADVANCED COMM. menu appears.
NOTE
You must press (Advanced Communication) within five seconds of entering
the fax number. If you wait longer than the interval, the machine starts to poll and
receive the documents. The timeout interval can be turned ‘OFF’. (See “Time Out
Mode,” on p. 4-7.)
Start
F3
Advanced
Communication