Canon IMAGERUNNER 2010F - Manual (Page 74)

Setting Up Speed Dialing 2-29
Speed Dialing
2
NOTE
• If you selected <01 USING # KEY>, you can assign the access code to (#).
• If you selected <02 OTHER>, you can assign the access code to any
one-touch speed dialing key. (See “Program One-Touch Keys,” on p. 10-3.)
8
Press [F3] (
▼) or [F4] (▲) to highlight <02 NO OF
CHARACTERS>
➞ press [OK].
The NO OF CHARACTERS menu appears.
9
Press [F2] (-) or [F3] (+) to enter the number of characters for
the access code
➞ press [OK].
The display returns to the SYSTEM SETTINGS menu.
IMPORTANT
If access codes are already registered for one-touch or coded speed dialing, the
message <THE ACCESS CODE IS ALREADY SET CHANGE THE SETTING
AFTER CLEARING> appears on the screen for about two seconds. You cannot
change the number of characters. Delete the access codes first, then change the
number of characters.
NOTE
• The access code can be two to five characters long.
• You can also use numeric keys to enter the number of characters for the access
code.
10
Press [Reset] to return to the Fax Basic Features screen.
F3
F4
OK
F2
F3
OK
Reset