Setting reports to print automatically, Tx reports, Setting reports to print automatically -2 – Canon IMAGERUNNER 2010F User Manual
Page 323: Tx reports -2, See “tx reports,” on p. 12-2.)
Setting Reports to Print Automatically
12-2
Pr
inting Repor
ts and Lists
12
Setting Reports to Print Automatically
This section describes how to print the reports of the TX/RX results or of TX/RX in
the memory boxes automatically.
TX Reports
Follow the procedure below to select whether to print the TX reports automatically.
You can also set to print reports only when a transmission error occurs.
NOTE
•
For TX report samples, see “Report Samples,” on p. 15-2.
•
You can set whether or not to print the TX image on the reports.
•
You can check if the document was sent to the other party correctly using the TX reports.
•
The default setting is ‘01 OUTPUT NO’.
1
Press Additional Functions.
The ADDITIONAL FUNCTIONS menu appears.
2
Press [F3] (
▼) or [F4] (▲) to highlight <03 FAX SETTINGS> ➞
press [OK].
Each time you press
(
▼) or
(
▲), the next or previous menu option
becomes highlighted.
The FAX SETTINGS menu appears.
Additional Functions
F3
F4
OK
F3
F4