4 p-bit translation table, 4 port filters – CANOGA PERKINS 9145 NID Software Version 6.0 User Manual
Page 55
9145 NID Software User’s Manual
The World Leader in Fiber Optic Communications Systems
45
5.2.3.4 P-Bit Translation Table
The 9145 can change P-Bit Tag IDs on user packets to change their priority status in the network.
To change incoming Priority Bit Translations, type 4 and press <Enter>. The P-Bit Translation
Table (see Figure 5-10) appears.
1. To modify the P-Bit translation data, type the number of the P-Bit you wish to translate,
from 1 to 8, and press <Enter>. Enter the P-Bit value and press <Enter>. Use <Tab> to
change columns. Press <Enter> to confirm changes.
2. To Enable or Disable P-Bit translation, type 9, press <Enter>, and use <Space> to toggle
between Yes and No. Use <Tab> to change columns. Press <Enter> to confirm changes.
Figure 5-10. P-Bit Translation Table
5.2.4 Port Filters
Port Filters allows the customer to set filters on the user and extension ports to filter certain man-
agement and control Ethernet frames from the data stream and control traffic coming out of spe-
cific ports, depending on the packet type. To configure the port filters, on the Port Configuration
menu, type 4, then press <Enter>. The Port Filters screen appears. To set the port filters, Type
the filter item number, 1 through 6, and press <Enter>.
PVST + BPDU Filter - When enabled, the 9145 will discard PVST and BPDU frames
received on the specified port. Use <Space> to toggle between User Port Enabled, Ext Port
Enabled, Both Ports Enabled, and Disabled.
Canoga Perkins Corp. Ethernet Network Interface Device 04-Jan-1970
Model 9145-4 V06.29 F117 02:59:35
-------------------------------P-BIT TRANSLATION TABLE--------------------------
Local Local Remote
User
Port
Ext
Port
Offline
1) Incoming P-Bit 0 translated to
0
2
2) Incoming P-Bit 1 translated to
1
3
3) Incoming P-Bit 2 translated to
2
4
4) Incoming P-Bit 3 translated to
3
7
5) Incoming P-Bit 4 translated to
4
3
6) Incoming P-Bit 5 translated to
5
2
7) Incoming P-Bit 6 translated to
6
0
8) Incoming P-Bit 7 translated to
7
1
9) P-Bit Translation Enabled?
Yes
Yes
Select [1-9]:
------------------------------------Messages------------------------------------