CANOGA PERKINS 9145 NID Software Version 6.0 - Manual (Page 72)

9145 NID Software User’s Manual
62 The World Leader in Fiber Optic Communications Systems
Figure 9-2. The OAM Control Screen
9.1.1 OAM Admin State
To set OAM Admin State parameters:
1. Type 1 and press <Enter>. The User Port column entry will be highlighted.
2. If you wish to change the User Port setting, use <Space> to change between Enabled
and Disabled, then press <Enter> to lock in the setting and move to the Extension Port
column.
3. If you do not want to change the User Port entry, use <Tab> to move the highlight to the
Extension Port entry. Use <Space> to change between Enabled and Disabled, then press
<Enter> to lock in the setting.
Canoga Perkins Corp. Ethernet Network Interface Device 04-Jan-1970
Model 9145-4 V06.29 F117 02:59:35
----------------------------------------OAM CONTROL-----------------------------
User Port Extension Port
--------- --------------
OAM Operational Status Link Fault Disabled
OAM Max PDU Size 1518 1518
OAM Revision 1 1
OAM Functions Supported Loopback Unidirectional
Link Events Loopback
Link Events
OAM Loopback Status
No Loopback No Loopback
OAM Remote Link Fault No No
1) OAM Admin State
Enabled Disabled
2) OAM Mode Active Active
3) OAM Loopback Command No Loopback No Loopback
4) Process Rx Loopback OAMPDU No No
5) Process Rx Link Fault Flag Yes Yes
6) Fwd Critical Event No No
Select [1-6]:
:------------------------------------Messages------------------------------------