CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 107)

Link OAM 9145E10G NID Software User’s Manual
OAM Peer Information
95
10.1.13 User interface MIB Objects
• FWD Critical Event cpDot3OamForwardCriticalEvent (cpdot3oam.my)
• OAM Admin State dot3OamAdminState (dot3oam.my)
• OAM Functions Supported dot3OamFunctionsSupported (dot3oam.my)
• OAM Loopback Command dot3OamLoopbackStatus (dot3oam.my)
• OAM Loopback Status Dot3OamLoopbackStatus (dot3oam.my)
• OAM MAX PDU Size dot3OamMaxOamPduSize (dot3oam.my)
• OAM Mode dot3OamMode (dot3oam.my)
• OAM Operational Status dot3OamOperStatus (dot3oam.my)
• OAM Remote Link Fault
• OAM Revision dot3OamConfigRevision (dot3oam.my)
• Process Rx Link Fault Flag cpDot3OamProcessRxLinkFault (cpdot3oam.my)
• Process Rx Loopback OAMPDU dot3OamloopbackIgnoreRx (dot3oam.my)
10.2 OAM Peer Information
This table contains information about the OAM peer for a particular Ethernet-like interface such
as OAM Peer Status, OAM Peer MAC Address, OAM Peer Vendor, OAM Peer Vendor Info (Hex),
OAM Peer Mode, OAM Peer Max PDU Size, OAM Peer Config Revision, and OAM Peer Func-
tions Supported. As indicated in eth figure below, there is one entry in this table for each port.
From the OAM Control screen, select OAM Peer Information (2) and press Enter. The OAM Peer
Information screen (Figure 10-1.) opens. Press Esc to return to the 802.3AH OAM menu.