CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 74)

9145E10G NID Software User’s Manual Port Information
Port Configuration
62
Figure 5-10. Port Filters Screen
1. PVST+ BPDU Filter - When enabled, the 9145E10G will discard PVST+ BPDU frames
received on the specified port. Use the Space Bar to select User Port Enabled, Net Port
Enabled, Both Ports Enabled, or Disabled.
2. User Port Manager MAC Filter - When enabled, the 9145E10G will block packets enter-
ing the unit which have the unit’s MAC address as the source MAC Address. This pre-
vents spoofing of Management frames. Use the Space Bar to cycle between User Port
Enabled and Disabled.
3. User Port Test Network Filter - When enabled, the 9145E10G will inspect and discard
all packets entering its User port that have a source IP address on the same subnet mask
as the Test network. This prevents spoofing of test packets. Use the Space Bar to cycle
between User Port Enabled and Disabled.
4. 802.3ah OAM PDU Filter - When enabled, the 9145E10G will block 802.3ah OAM PDU
frames from being generated from or passed through the unit. If the user intends to use
OAM, this filter must be disabled. Use the Space Bar to cycle between Enabled and Dis-
abled.
5. UDLD Filter - When enabled, the 9145E10G will block Cisco Systems proprietary tagged
and untagged UDLD frames from passing through the unit. Use the Space Bar to cycle
between Enabled and Disabled.
6. Management VLAN Filter - When enabled, the 9145E10G will block traffic that is tagged
with the Management VLAN on the specified port. This will not affect management pack-
ets that are addressed to the 9145E10G. Use the Space Bar to cycle between Disabled,
User Port Enabled, Net Port Enabled and Both Ports Enabled.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
----------------------------------PORT FILTERS---------------------------------
1) PVST+ BPDU Filter Disabled
2) User Port Manager MAC Filter User Port Enabled
3) User Port Test Network Filter User Port Enabled
4) Link OAM PDU Filter Disabled
5) UDLD Filter Enabled
6) Management VLAN Filter Both Ports Enabled
Select [1-6]:
------------------------------------Messages-----------------------------------