CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 73)

Port Information 9145E10G NID Software User’s Manual
Port Configuration
61
5.2.3.3 P-Bit Translation Table
The 9145E10G can change the P-Bit setting in VLAN ID tags on Service frames to change their
priority status in the network. To change incoming Priority Bit Translations, type 3 and press
Enter. The P-Bit Translation Table (Figure 5-9.) opens.
1. To modify the P-Bit translation data, type the number of the P-Bit you wish to translate,
from 1 to 8, and press Enter. Enter the P-Bit value and press Enter. Use Tab to switch
between ports. The P-Bit will be changed on the ingress direction for the port. Press
Enter to confirm changes. Press Enter to confirm changes.
2. To Enable or Disable P-Bit translation, type 9, press Enter, and use the Space Bar to
select between Yes and No. Use Tab to switch between ports.
Figure 5-9. P-Bit Translation Table
5.2.4 Port Filters
Use Port Filters to set filters on the User and Network ports to filter certain management and con-
trol Ethernet frames from the data stream and control traffic coming in or out of specific ports.
To configure the port filters, select Port Filters (4) from the Port Configuration menu and press
Enter. The Port Filters screen (Figure 5-10) opens. To set the port filters, type the filter item num-
ber, 1 through 6, and press Enter.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
-------------------------------P-BIT TRANSLATION TABLE-------------------------
User Port Net Port
1) Incoming P-Bit 0 translated to 0 0
2) Incoming P-Bit 1 translated to 1 1
3) Incoming P-Bit 2 translated to 2 2
4) Incoming P-Bit 3 translated to 3 3
5) Incoming P-Bit 4 translated to 4 4
6) Incoming P-Bit 5 translated to 5 5
7) Incoming P-Bit 6 translated to 6 6
8) Incoming P-Bit 7 translated to 7 7
9) P-Bit Translation Enabled? No No
Select [1-9]:
------------------------------------Messages-----------------------------------