CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 76)

9145E10G NID Software User’s Manual Port Information
Layer 2 Statistics
64
5. Delete Range - This function is used to remove a group of VLAN IDs from the screen list.
Enter the group of VLAN IDs you want to remove and press Enter. The value must be
between 2 and 4094.
5.3 Layer 2 Statistics
To view Layer 2 statistics, select Layer 2 Statistics (3) from the Port Information screen (Figure 5-
1.) and press Enter. The Layer 2 Statistics screen (Figure 5-12.) opens. Use the controls as
listed to view the Layer 2 Statistics screen. Press Esc to return to the Port Information screen.
Figure 5-12. Layer 2 Statistics Screen
1. Change Counter Frame Size - The 9145E10G has a programmable counter for frames
greater than the programmed size. Type C and press Enter. Type in the desired frame
size, between 64 and 10,000, and press Enter to accept change.
2. Error Counters - Type E and press Enter to view the Layer 2 Error Statistics screen
(Figure 5-13.).
3. Frame Type Counters - Type T and press Enter to view the Layer 2 Frame Type Statis-
tics screen (Figure 5-14.).
4. Raw Counters - These are the total counters since the last time the 9145E10G was
reset. Press Ctrl+T to view raw layer 2 statistics.
5. Reset Counters - Press Ctrl+R to reset the counters. The counters are reset indepen-
dently of the raw counters. The raw counters can not be cleared.
6. Frame Counters - Press F (available on Layer 2 Error Statistics and Layer 2 Frame
Type Statistics menus) to return to the Layer 2 Statistics screen.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
--------------------------LAYER 2 STATISTICS (CURRENT)--------------------------
User Port Net Port MPP Port
Link State ** DOWN ** UP ** DOWN **
Speed/Duplex N/A 10000M/FULL N/A
Frames Sent 0 105466 0
Frames Rcvd 0 31806714 0
Bytes Sent 0 13305612 0
Bytes Rcvd 0 43479287658 0
Frames > 1518 0 0 0
Frames > 1522 0 0 0
Line Rate Utilization 0% 0% 0%
Last Counter Reset: 1 day 18:34:08
Select [(C) Change Counter Frame Size, (E) Error Counters,
(T) Frame Type Counters, (CTRL-T) Raw Counters, (CTRL-R) Reset Counters]:
------------------------------------Messages-----------------------------------