CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 96)

9145E10G NID Software User’s Manual Software Upgrade
Swap Bank After Download and Reset
84
NOTE: All users will be logged off during the 9145E10G reset. If the new
software version has a new FPGA version, payload traffic through
the 9145E10G Could be affected during the FPGA reprogramming.
To swap banks and reset the 9145E10G, type 2 and press Enter. Swap will be highlighted. Press
Enter. The flash memory banks will be swapped and the 9145E10G will reset.
NOTE:The software on the new inactive flash memory bank will remain in
memory and not be deleted.
Figure 8-1. Software Upgrade Screen
8.3 Swap Bank After Download and Reset
Option 3 allows you to select automatically swapping banks on reset after a successful down-
load. Select Yes for automatically swap banks. Select No to have downloaded software remain in
the inactive bank. This option does not generate a reset.
Type 3 and press Enter. Press the Space Bar to cycle between Yes and No.
NOTE:Users will be disconnected when the 9145E10G is reset.
The flag must be set before the download of the new software while Swap Bank after Download
and reset is set. After downloading software, the message line will read Loads xx.xx on Next
Reset.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
------------------------------------SOFTWARE UPGRADE--------------------------
Time Since Last Restart 03:23:15
Version File Name File Size
Active Firmware 00.00 9145E-A00(CL31)-00-00.ZIP 3008191
Inactive Firmware 50.08 9145E-A30-50-08.ZIP 3049460
Bootcode 02.31 9145E-B00-02-31.BIN 339018
1) Software Reset Reset
2) Swap Bank & Reset Swap
3) Swap Bank after
download and reset Yes
4) Get New File with TFTP
Select [1-4]:
----------------------------------Messages-------------------------------------