CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 88)

9145E10G NID Software User’s Manual Utilities
Set Date and Time
76
7.1 Set Date and Time
To set the correct date and time, type 1 and press Enter. Type the current date & time in DD/MM/
YYYY HH:MM:SS format. Press Enter to confirm the setting. Note that SNTP will overwrite the
setting on the next poll if SNTP is enabled.
Figure 7-2. Set Date and Time
7.2 Reset Configuration To Default
To reset the configuration to the default settings, type 2 and press Enter. At the bottom of the Util-
ities menu after “Reset configuration with factory default values and reset module?”, type Y and
press Enter. All values, with the exception of Manager IP Address, Subnet Mask, Default Gate-
way, Management Port, VLAN State, VLAN Number, Test IP and Subnet Mask, and User and
Network Port settings will be returned to factory settings and the system will be reset.
NOTE:During reset all host connections will be terminated.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
---------------------------------------UTILITIES-------------------------------
1) Set Date and Time
2) Reset Configuration To Default
3) Change Password
4) VT100 Baud Rate 9600
5) PING Generation
6) Static ARP Table
7) Dynamic ARP Table
Date :
Type Current Date & Time (e.g., DD/MM/YYYY HH:MM:SS),
and Hit 'Enter' to validate
----------------------------------Messages-------------------------------------