CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 50)

9145E10G NID Software User’s Manual System Configuration
SYSLOG Client Configuration
38
3.8 SYSLOG Client Configuration
Use the SYSLOG Client Configuration screen to configure the 9145E10G to send log messages
to a SYSLOG Server. From the System Configuration menu, select SYSLOG Client Configura-
tion (8) and press Enter. The SYSLOG Client Configuration screen (Figure 3-20.) opens.
On the SYSLOG Client Configuration screen, type the number of the SYSLOG setting to change
and press Enter. When entries are completed, press Esc to return to the System Configuration
menu.
Figure 3-20. SYSLOG Client Configuration screen
1. Syslog Server IP Address - Configure the IP address of the Syslog server. Two Syslog
servers can be configured.
2. Syslog Server Port - Configure the Syslog Server port. The standard syslog port is 514.
The port setting should match with the Syslog server UDP port setting (1 - 65535).
3. Syslog Server Mask - Define the level of severity of the messages to be send. There are
eight (8) levels of severity as defined in RFC 3164. The severity levels from highest to low-
est are:
• Emergency:
• System is unusable.
• Alert:
• Action must be taken immediately.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
-------------------------SYSLOG CLIENT CONFIGURATION---------------------------
1. Syslog Server IP Address : 000.000.000.000
Syslog Server Port : 514
Syslog Server Mask : Debug
2. Syslog Server IP Address : 000.000.000.000
Syslog Server Port : 514
Syslog Server Mask : Debug
Select [1-2]:
-----------------------------------Messages------------------------------------