CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 26)

9145E10G NID Software User’s Manual System Configuration
IP/SNMP Agent Configuration
14
8. Reply to Broadcast Ping - Use to enable or disable the 9145E10G to reply to ICMP
packets with a broadcast IP Host Address in the Manager IP subnet. Broadcast Ping
replies are an ICMP packet and are rate limited to 100pps. Default is disabled.
3.1.2 Auxiliary IP Configuration
The Auxiliary IP is an additional IP address that is provided for testing and connectivity only. It
allows the 9145E10G to be PINGed without allowing Telnet or Management access that could be
disruptive. The Auxiliary IP rate is limited to 500 pings per second. This allows connectivity and
rudimentary performance testing from subscriber/user VLANs without compromising network
security.
Figure 3-4. Auxiliary IP configuration Menu
Configure the parameters by typing the corresponding number and pressing Enter. Enter data or
press the Space Bar to cycle through the configuration choices for the parameters described
below.
1. Auxiliary IP Address - Sets the 9145E10G Auxiliary IP Address.
Auxiliary Subnet Mask - Sets the 9145E10G Auxiliary IP Subnet Mask.
2. Inband Auxiliary Port - Describes the Auxiliary IP address ports. Allows the customer to
select No Ports, User Port Only, Net Port Only, or Both User and Net Ports.
3. Auxiliary VLAN Tagging - Enable or Disable Auxiliary IP VLAN Tagging.
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
-------------------------------AUXILIARY IP CONFIGURATION----------------------
1) Auxiliary IP Address 000.000.000.000
Auxiliary Subnet Mask 255.255.255.000
2) Inband Auxiliary Port Both User and Net Ports
3) Auxiliary VLAN Tagging Disabled
4) Auxiliary VLAN Number 0
5) Allow Any Vlan Disabled
6) Aux IP Rate Limiting Enabled
Select [1-6]:
------------------------------------Messages-----------------------------------