CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 79)

Port Information 9145E10G NID Software User’s Manual
RMON Group 1 Statistics
67
CRC Errors - reports the number of frames received on the interface that had a length (excluding
framing bits, but including the CRC) of between 64 and the Maximum Frame Size, inclusive, but
had a bad CRC. The interface will discard the frame.
Jabber Events - reports the number of frames received on the interface that had a length greater
than 1518 and had a bad CRC. This follows the definition in the RMON RFC.
Dropped - reports the number of frames that the interface was unable to transmit due to
buffer overflow, link failure, or due to some of the filter settings.
5.3.1.3 Layer 2 Frame Type Statistics
Frames Sent - reports the total number of frames sent from the interface since the last reset
(Raw) or the last counter reset (Current).
Frames Rcvd - reports the total number of valid frames received on the interface since the last
reset (Raw) or the last counter reset (Current).
Rx Broadcasts - reports the number of broadcast frames received on the interface.
Tx Broadcasts - reports the number of broadcast frames transmitted by the interface.
Rx Multicasts - reports the number of multicast frames received on the interface.
Tx Multicasts - reports the number of multicast frames transmitted by the interface.
VLAN Tagged - reports the number of VLAN tagged frames received on the interface.
Pause Frames - reports the number of PAUSE frames received by the interface.
Filtered Frames - reports the number of frames received on the interface that were dropped due
to filtering rules.
Rx Management - reports the number of frames received on the interface that were passed to the
9145E10G manager.
Tx Management - reports the number of frames received from the 9145E10G manager that were
passed to the interface.
5.4 RMON Group 1 Statistics
To view Remote Monitoring Specification (RMON) statistics, select RMON Group 1 Statistics (4)
from the Port Information screen (Figure 5-1.) and press Enter. The RMON Group 1 Statistics
screen (Figure 5-15.) opens.
Follow the instructions at the bottom of the RMON Group 1 Statistics screen to view the informa-
tion listed below. Press Esc to return to the Port Information screen.
1. Select More - Type M and press Enter to page through all available screens. By clicking
on (M) More you will see a second screen with additional RMON stats parameters.
2. Raw Counters - Type Ctrl+T to view the raw RMON Group 1 Statistics.
3. Reset Counters - Press Ctrl+R to reset the counters. The counters are reset indepen-
dently of the raw counters. The raw counters can not be cleared.