CANOGA PERKINS 9145EMP NID Software Version 3.1 - Manual (Page 121)

CoS Configuration 9145EMP NID Software User’s Manual
CoS Queues Configuration
109
To enable or disable a queue, see “Queues Configuration on Network Ports” on
page 116.) Network ports support PCP only.
Figure 10-6 Network Port Tagged Packet Classifier Mapping screen
10.3.1.1 Mapping a Queue on the User Port in C-VID Mode
If you selected C-VID for the User port, you can use the User Port Tagged Packet Classifier
Mapping screen (C-VID Mode) (Figure 10-7) to select a port, change the queue assignment, and
view the queue assignment of a particular C-VLAN or range of C-VLANs. The screen displays
the first 40 C-VID queue assignments. To view more, use step 3, below.
1. To change User port, on the User Port Tagged Packet Classifier Mapping screen (C-VID
Mode), type 1 and press Enter. Use the Space bar to select a User port, and then press
Enter.
2. To change the queue assignment, type 2 and press Enter.
• Enter a C-VLAN ID (C-VID) or a range of IDs from 1-4094 and press Enter.
• Enter the queue ID (1-3) for Q1-Q3 or 4 for LLQ. and press Enter. The queue
assignment changes to the new value. (Only a queue that is enabled can be
selected. To enable or disable a queue, see “Queues Configuration on Network
Ports” on page 116.)
3. To view the queue assignment of a particular C-VID (other than the first 40 already shown
on your screen), type 3 and press Enter.
• Enter a C-VLAN ID (C-VID) and press Enter. The screen displays a page of 40 C-
VIDs, including the C-VID you selected.
Canoga Perkins Corp. Ethernet Network Interface Device 20-MAR-2010
Model 9145EMP-761-0-0 V11.03 F11 Canoga 9145EMP 32 device 21:52:40
--------------- NETWORK PORT TAGGED PACKET CLASSIFIER MAPPING ------------------
PCP Queue
--- ---
0 LLQ
1 Q1
2 Q1
3 Q1
4 Q2
5 Q2
6 Q3
7 Q3
Select [0-7]:
------------------------------------Messages-----------------------------------