CANOGA PERKINS 9145EMP NID Software Version 3.1 - Manual (Page 161)

Service OAM 9145EMP NID Software User’s Manual
Maintenance End Points
149
3. Type an MA ID or MEG ID and press Enter. (To view a list of MA/MEGs, press CTRL-L,
type S to select, and press Enter.) The MEP ID field is highlighted.
4. Type a MEP ID and press Enter. The Admin Status field is highlighted.
5. In the Admin Status field, select Enabled or Disabled and press Enter. The Direction field
is highlighted.
6. In the Direction field, select Up to identify a MEP that transmits CFM PDUs towards, and
receives them from, the direction of NID interworking. Select Down to identify a MEP that
receives CFM PDUs from, and transmits them towards, the direction of the wire. Press
Enter. The Port field is highlighted.
7. In the Port field, select USR1, USR2, USR3, USR4, or NET1. (The list of accessible ports
for the MEP will be dynamically filled depending on configuration of the appropriate MA/
MEG.)
8. To accept the new Maintenance End Point settings, type A and press Enter. The Mainte-
nance End Point Attributes screen (Figure 11-20 for 802.1ag or Figure 11-21 for Y.1731)
opens.
9. To modify an attribute value, type the number of the attribute and press Enter, or press
Esc to return to the Maintenance End Point List screen.
Figure 11-18 Create a New Maintenance End Point screen (for 802.1ag)
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2009
Model 9145EMP-761-0-0 V07.11 F7 Canoga 9145EMP 32 device 05:15:27
----------------------CREATE A NEW MAINTENANCE END POINT------------------------
1) MEG ID 1
MEP ID: 1
3) Admin Status: Enabled
4) Direction: Down
5) Port: NET1
Select [1-5] for attributes:
------------------------------------Messages-----------------------------------