CANOGA PERKINS 9145EMP NID Software Version 3.1 - Manual (Page 171)

Service OAM 9145EMP NID Software User’s Manual
Maintenance End Points
159
Figure 11-27 SOAM Linktrace Report screen
11.6.7 Loopback Procedures
A loopback request is initiated by a MEP to verify the connectivity to a specified target MEP or
MIP in the network.
NOTE: Only one Loopback session can be active at a time for the entire system.
11.6.7.1 Initiating a Loopback Request
1. On the Maintenance End Point Attributes screen (Figure 11-20 for 802.1ag or Figure 11-
21 for Y.1731), type L and press Enter.
• If a Loopback request was already initiated from the MEP, a Loopback Monitoring
screen (Figure 11-28 for unicast, Figure 11-29 for sweep, or Figure 11-30 for mul-
ticast) opens.
• Otherwise, the Loopback Request screen (Figure 11-31) opens.
2. To change the loopback mode, on the Loopback Request screen, type 1 and press Enter.
• For 802.1ag, select unicast regular or unicast sweep.
• For Y.1731, select unicast regular, unicast sweep, or multicast.
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2009
Model 9145EMP-761-0-0 V07.11 F7 Canoga 9145EMP 32 device 05:15:27
------------------------------SOAM LINKTRACE REPORT ----------------------------
Source MEP ID: 1
Destination: Mep ID: 2
MAC: 00:40:2A:01:ED:E3
Destination reached: Yes
Number of hops to destination: 1
Number of replies: 1
Reply number: 1
TTL: 62
Responder MAC address: 00:40:2A:01:ED:E3
LTM was forwarded: No
Terminal MEP was reached: Undefined
Relay action: Undefined
Egress action: Ok
Egress address: 00:40:2A:01:ED:E3
Select [(F)irst, (P)rev, (N)ext, (L)ast] to change pages,
R)efresh, ESC to return:
------------------------------------Messages-----------------------------------