CANOGA PERKINS 9145EMP NID Software Version 3.1 - Manual (Page 67)

Port Information 9145EMP NID Software User’s Manual
Port Configuration
55
3. User Side Test Network Filter When this attribute is enabled, the 9145EMP will inspect
and discard all packets entering its User port that have a source IP address on the same
subnet mask as the Test network. This prevents spoofing of test packets. Press the Space
bar to select Enabled or Disabled.
4. Link OAM PDU Filter When this attribute is enabled, the 9145EMP will block Link OAM
PDU frames from being generated from or passed through the unit. Press the Space bar
to select Enabled or Disabled.
5. UDLD Filter When this attribute is enabled, the 9145EMP will block Cisco Systems
proprietary tagged and untagged UDLD frames from passing through the unit. Press the
Space bar to select Enabled or Disabled.
6. Management VLAN Filter When this attribute is enabled, the 9145EMP will block traffic
that is tagged with the Management VLAN on the specified port. This will not affect
management packets that are addressed to the 9145EMP. Press the Space bar to select
Disabled, User Ports Enabled, Net Ports Enabled, or All User and Net Ports Enabled.
Figure 5-6 Port Filters screen
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
Model 9145EMP-761-0-0 V07.11 F7 10:21:49
----------------------------------PORT FILTERS---------------------------------
1) PVST+ BPDU Filter Disabled
2) User side Manager MAC Filter Enabled
3) User side Test Network Filter Enabled
4) Link OAM PDU Filter Disabled
5) UDLD Filter Enabled
6) Management VLAN Filter Disabled
Select [1-6]:
------------------------------------Messages-----------------------------------