Panasonic WV-CU20 - Manual (Page 112)

(D MATRIX SWITCHER CONFIGURATIONS
Select and enter the same parameters for the following
as set for the WJ-SX550 A/B, except the NT204 UNIT
ADDRESS.
OPERATOR NUMBER
PASSWORD
WAIT TIME
CONTROL PROCEDURES
CONTROL PRIORITY(RS232C}
NT204 UNIT ADDRESS
When NONE ENQ is selected for CONTROL PROCE­
DURES, set the address to "1".
When ENQ/ACK is selected, set an appropriate
address,
® VIDEO-INPUT NUMBER AND MONITOR-OUT CHAN­
NEL SETUP
Set a channel number for the monitor output of the WJ-
SX550B Matrix Switcher to be connected to the video
input connector on the WJ-NT204 network interface
unit. The status when selecting VIDEO-INPUT (at WJ-
NT204) in the previous page table is the same as when
a monitor compatible with the WJ-SX550B is selected.
• Control Operation
On the Location bar, type the URL http;//192.168.0.10/ to access the WJ-SX550B OPERATION VIEW window for the Matrix
Switcher.
■ 4. Xi-
.. I
(D WJ-SX550 A/B OUTPUT
Selects any of the four video inputs of the Interface Unit
for display on the monitor. Set the monitor outputs of
the Matrix Switcher to match the video inputs of the
Interface Unit.
The video channels will be switched in accordance
with the operating mode selected.
© CAMERA SELECT (Left window panel)
To select a camera (camera 01 to 08) connected to the
WJ-SX550B Matrix Switcher. The image of the selected
camera is displayed on the monitor in the previously
selected input mode.
© PRESET SELECT (Left window panel)
To move the combination camera (option) connected to
the WJ-SX550B to any of 8 preset positions.
® CAMERA PRESET REGISTRATION
Register up to 64 camera preset positions of that the
cameras connected to the WJ-SX550 A/B.
112