Panasonic WV-CU20 - Manual (Page 113)

(D LOGOUT
Logs out of the WJ-SX550 control operation.
© CAMERA SELECT (Bottom window panel)
To select a camera (CAMERA 1 to 128) connected to
the WJ-SX550B. Select a camera number, and then
click [SET] to apply it. The image of the selected cam­
era is displayed on the monitor in the previously select­
ed input mode.
Q) PRESET SELECT (Bottom window panel)
To move the combination camera (option) connected to
the WJ-SX550B to any of 64 preset positions. Select a
preset position number, and then click the [SET] button
to move the camera to the position.
© ALARM ALL RESET
To reset all alarms activated in the Matrix S\A/itcher, and
return it to normal condition.
Note: Follow the resetting procedures for each alarm
mode setup in the WJ-SX550A/B.
• When MODE 1 is set, select the MONITOR 1,
then reset the alarm.
• When MODE 2 is set, select any of the MONI­
TOR 1 through 4, then reset the alarm.
• When MODE 3 is set, select the same MONI­
TOR that is set in the WJ-SX550A/B, then reset
the alarm.
© PAN/TILT
Click on any of the pan/tilt buttons: Up, Down, Right or
Left to move the pan/tilt head of the Combination cam­
era to the desired direction. Click the button repeatedly
as necessary not holding down it.
® ZOOM
Click the button to zoom in or out. Instead holding
down the button, dick on it repeatedly as necessary.
TELE: Zooms in the image.
WIDE: Zooms out the image.
@ FOCUS
Click NEAR or FAR to adjust the focus of the image
manually. Instead holding down the button, click on it
repeatedly as necessary.
NEAR: Manual focusing
FAR: Manual focusing
AUTO; The built-in focus mechanism performs in the
Combination camera.
@ IRIS
The connected combination camera (option) can be
controlled to close or open iris by clicking the [CLOSE]
or [OPEN] button under IRIS.
Clicking the [OPEN] or [CLOSE] button will open or
close the camera iris for a specified time, after which,
the operation is released automatically.
Clicking the [RESET] button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN] or [CLOSE] button depressed. You need to
click the [OPEN] or [CLOSE] button again.
® AUTO PAN
The auto pan status of the connected combination
camera (option) can be changed by clicking the
[ON]or [OFF] button under AUTOPAN.
Note: When LOCAL is selected in the camera setup
menu, auto pan is released automatically within 1
minute. When REMOTE is selected, auto pan will
not be released automatically.
0 Status Display
Displays information when an alarm is activated on the
Matrix Switcher.
0) Image Display
Displays the image output supplied from the Matrix
Switcher connected to the WJ-NT204. Set the monitor
outputs of the Matrix Switcher to match the video inputs
of the WJ-NT204.
113