Panasonic WV-CU20 - Manual (Page 131)

SONTENirS UPiOAD
Contents upload to the WJ-NT204 transmitter can be made
using a File Transfer Protocol (FTP), A single PC is allowed
to upload at a time. Uploading may take time when the
transmitter is in communication with a receiver or PC. It is
recommended that you disconnect communication for mon­
itoring image prior to login. The login procedures are
described below.
■ Uploading a File
Upload contents produced by using a PC by the following
procedures.
© Click the [Start] button, point to Programs, and then
click MS-DOS Prompt to open the MS-DOS window,
@ Enter an FTP command in the MS-DOS window and
start the FTP. Then enter the IP address of the WJ-
NT204.
C;\CONTENTS>FTP 192.168.0.10
Content Storage Memory
Content files such as HTML that have been uploaded
by means of the FTP are stored in the flash ROM of the
WJ-NT204. Hence, they are protected from erasure
when the power switch is turned off. However, they are
returned to an initial state during version-up operation
or if reset after turning on the Mode Setup Switch "2” of
the WJ-NT204. Make sure to back up the files before
attempting to conduct such operations.
No directories can be prepared in the content memory
interior,
Reading of the contents file name is case-sensitive,
Storing capacity: Approx. 200 kBytes in total
Number of storable files ; Max. 100
* The above figures are subject to change, depend­
ing on file sizes and memory usage.
@ In response to the input request for a user account, log
in the user at the administrator level {Level 1),
User (192,168.0.10 : (none)): admin
® Enter a password.
Password:
This column will not appear until you enter a new pass­
word,
® After finishing the log-in operation, enter “bin" to select
a binary transmission mode.
ftp>bin
® Enter a put command to upload the file.
ftp>put upload.html
@ After finishing the transmission, enter "quit" to exit from
the FTP.
ftp>quit
Notes
To transmit more than one file at a time, enter “prompt" to
release the interactive mode, and follow “mput" of the input
command with a wild card symbol (for example, "*’’).
ftp>prompt
interactive mode off
ftp>mput * .htmi
131