Mounting in the rack, Caution, Accessory switch protector – Panasonic WV-CU20 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Mounting in the Rack
-Caution
Do not block the ventilation opening or slots on the cover \which prevent the appliance from overheating.
Always keep the temperature on the rack within A5°C (113“F),
Secure the rear of the appliance to the rack using the additional mounting brackets (procured locally) if the rack is
subject to vibration.
1. Loosen the four screws to remove the four rubber feet
from the bottom of the Network Interface Unit.
2. Place the rack mounting brackets on both sides of the
Network interface Unit and tighten them with the six
supplied screws.
3. install the Network interface Unit with the rack mount
ing brackets in the rack using four screws (not includ
ed).
M3 (supplied)
Accessory Switch Protector -------------------------------------------------------------------------
If this switch protector is used, then it is possible to avoid the Network Interface Unit being
turned off by careless pressing of the unit POWER switch.
In case of gang power ON/OFF operation incorporated in the rack, the unit POWER switch
must always be moved to the ON position and the accessory switch protector should be
mounted.
18