Panasonic WV-CU20 - Manual (Page 49)

620 REMOTE CLOCK SETUP (Receiver during
Communication)
This menu enables the Control site to adjust the transmit­
ter’s clock during communication.
1, Open the 620 REMOTE CLOCK SETUP menu.
2. Press the ENTER button when the local time is the hour.
The clock on the transmitter is adjusted to the hour with
a delay of 2 or 3 seconds due to transmission. The
adjustment is accepted only when the deviation is with­
in plus or minus 3 minutes from the hour.
630 COM RATE/INFO.
This menu helps you to analyze failures in communication
such as disconnection.
1. Open the 630 COM RATE/INFO. menu.
630 COM RATE/IHFO.
COM STATE/DISC VALUE:
COM INTO.:
ESC:PRV
2. Observe the COM STATE display.
•: In-communication
Standby
3. Observe the cause display.
COM INFO, is not used.
The suspended call and calling log can be displayed for
reference.
640 CALLING LOG
640 CALLINO LOO
641 CALLED LOO IH COMI
642 CALLIMQ LOOl
Tl:MOVE ENT;SELECT ESCjPRV
1. Open the 640 CALLING LOG menu.
2. Move the cursor to the 641 or 642 with the A or T but­
ton, then press the ENTER.
The selected menu appears.
641 CALLED LOG IN COM
You can later check the caller number that is the latest sus­
pended in-communication status.
1. Open the 641 CALLED LOG IN COM menu.
You can check the registered name and address, and
received date and time on the monitor. This log will be
lost when the unit is turned off the power.
2. Press the ESC button to return the menu to the previ­
ous.
642 CALLING LOG
This log lists up to 100 of calling events with the event num­
ber, date and time, event type, and name and address of
the site concerned. The older records are overwritten when
more than 100 events take place.
49