Ф one-touch dialing registration, Re-connection, D host port – Panasonic WV-CU20 User Manual
Page 96: On screen display, Lock/password, 320 one touch dialing regi
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Ф ONE-TOUCH DIALING REGISTRATION
The five ONE TOUCH DIAL buttons on the Remote
Controller can be assigned the start point of sequential
dial (SEQ. DIAL) or one-touch dial numbers. Pressing
the one-touch button will call the start point of SEQ.
DIAL if it is registered as "000". Pressing other one-
touch dial buttons than “ООО" will call the assigned IP
address to the button.
® RE-CONNECTION
Re-connection is started by the site that is set to ON for
this setting when a call is interrupted during communi
cation. This setting is applicable only to the system
comprising two WJ-NT204 units, one for TRANSMITTER
and the other for RECEIVER, and when the call has
been made with the Remote Controller WV-CU20, This
does not perform in the multi-site connection.
(D
HOST PORT
The DIP switch #9 on the front of the WJ-NT204 unit
specifies the usable serial port from RS-232C (front) or
RS-485 (rear) (PS'Data). The settings must be the same
among the devices connected in the chain, except the
unit #.
® ON SCREEN DISPLAY
Elements displayed on the monitor connected to the
WJ-NT204 transmitter are selected to ON or OFF.
® LOCK/PASSWORD
MENU LOCK enables (ON) or disables (OFF) the pass
word protection when opening the menu windows.
NUM LOCK enables (ON) or disables (OFF) the numer
ic buttons to operate on the Remote Controller.
A PASSWORD comprises 4-digit of numeric characters
(0-9), asterisk (*) and sharp (#).
96